Miller Electric IH User Manual
Page 46
Advertising
OM-203 185 Page 42
scrn20
To remove a TC, click on the TC#
(Point ID), then click “Delete
Point”.
To edit a TC trace properties, select
a TC# (Point ID), then click “Point
Properties...”.
Select “OK” to return to the chart.
scrn21
Span − dictates the range of tem-
perature to plot for the trace.
Interpolation On − will show a
smoothed line between points
instead of steps.
Interpolation adds an “I” to end of
descriptor.
Select “OK” when done.
Advertising
This manual is related to the following products: