Maxtor QUICKVIEW 300 - Manual (Page 16)

General Description
Quickview 300 80/100/120/160/200/250/300GB PATA 2-3
Versatility
• Quiet mode
• Power saving modes
• Downloadable firmware
• Cable select feature
• Ability to daisy-chain two drives on the interface
2.3 REGULATORY COMPLIANCE STANDARDS
Maxtor Corporation’s disk drive products meet all domestic and
international product safety regulatory compliance requirements.
Maxtor’s disk drive products conform to the following specifically marked
Product Safety Standards:
• Underwriters Laboratories (UL) Standard 1950. This
certificate is a category certification pertaining to all 3.5-inch
series drives models.
• Canadian Standards Association (CSA) Standard C.22.2 No.
1950. This certificate is a category certification pertaining to
all 3.5-inch series drives models.
• TUV Rheinland Standard EN60 950. This certificate is a
category certification pertaining to all 3.5-inch series drives
models.
• This product meets the EC Directive on Waste Electrical and
Electronic Equipment (WEEE) and the EC Directive on the
Restriction of the Use of Certain Hazardous Substances in Electrical
and Electronic Equipment (RoHS)
Product EMI/EMS Qualifications:
• CE Mark authorization is granted by TUV Rheinland in
compliance with our qualifying under EN 55022:1994 and EN
50082-1:1997.
• C-Tick Mark is an Australian authorization marked noted on
Maxtor’s disk drive products. The mark proves conformity to
the regulatory compliance document AS/NZS 3548: 1995
and BS EN 55022: 1995.
• Maxtor’s disk drives are designed as a separate subassembly that
conforms to the FCC Rules for Radiated and Conducted emissions,
Part 15 Subpart J; Class B when installed in a given computer
system.
• Approval from Taiwan BSMI. Number: 3892A638