Table 5-2, Word content description – Maxtor QUICKVIEW 300 User Manual
Page 54
ATA Bus Interface and ATA Commands
5-12 Quickview 300 80/100/120/160/200/250/300GB PATA
85
7:
1 = release interrupt enabled
6:
1 = look-ahead enabled
5:
1 = write cache enabled
4:
Shall be cleared to zero to indicate that the PACKET Command feature set is
not supported.
3:
1 = Power Management feature set enabled
2:
1 = Removable Media feature set enabled
1:
1 = Security Mode feature set enabled
0:
1 = SMART feature set enabled
86 Command
set/feature
enabled.
15-14: Reserved
13:
1 = FLUSH CACHE EXT command supported
12:
1 = FLUSH CACHE command supported
11:
1 = Device Configuration Overlay supported
10:
1 = 48-bit Address features set supported
9:
1 = Automatic Acoustic Management feature set enabled
8:
1 = SET MAX security extension enabled by SET MAX SET PASSWORD
7:
See Address Offset Reserved Area Boot, INCITS TR27:2001
6:
1 = SET FEATURES subcommand required to spin-up after power-up
5:
1 = Power-Up In Standby feature set enabled
4:
1 = Removable Media Status Notification feature set enabled
3:
1 = Advanced Power Management feature set enabled
2:
1 = CFA feature set enabled
1:
1 = READ/WRITE DMA QUEUED command supported
0:
1 = DOWNLOAD MICROCODE command supported
87 Command
set/feature
default.
15:
Shall be cleared to zero
14:
Shall be set to one
13-8:
Reserved
7:
1 = WRITE DMA QUEUED FUA EXT command supported
Table 5-2
Identify Drive Command Parameters
Word
CONTENT DESCRIPTION