Table 5-2, Word content description – Maxtor QUICKVIEW 300 User Manual
Page 53
ATA Bus Interface and ATA Commands
Quickview 300
80/100/120/160/200/250/300GB PATA
5-11
83
7:
See Address Offset Reserved Area Boot, INCITS TR27:2001
6:
1 = SET FEATURES subcommand required to spinup after power-up
5:
1 = Power-Up In Standby feature set supported
4:
1 = Removable Media Status Notification feature set supported
3:
1 = Advanced Power Management feature set supported
2:
1 = CFA feature set supported
1:
1 = READ/WRITE DMA QUEUED supported
0:
1 = DOWNLOAD MICROCODE command supported
84
Command set/feature supported extension.
15:
Shall be cleared to zero
14:
Shall be set to one
13-8:
Reserved
7:
1 = WRITE DMA QUEUED FUA EXT command supported (ATA-7)
6:
1 = WRITE DMA FUA EXT and WRITE MULTIPLE FUA EXT commands
supported (ATA-7)
5:
1 = General Purpose Logging feature set supported
4:
1 = Streaming feature set supported (ATA-7)
3:
1 = Media Card Pass Through Command feature set supported
2:
1 = Media serial number supported
1:
1 = SMART self-test supported
0:
1 = SMART error logging supported
85 Command
set/feature
enabled.
15:
Obsolete
14:
1 = NOP command enabled
13:
1 = READ BUFFER command enabled
12:
1 = WRITE BUFFER command enabled
11:
Obsolete
10:
1 = Host Protected Area feature set enabled
9:
1 = DEVICE RESET command enabled
8:
1 = SERVICE interrupt enabled
Table 5-2
Identify Drive Command Parameters
Word
CONTENT DESCRIPTION