Maxtor QUICKVIEW 300 - Manual (Page 27)

Installation
Quickview 300 80/100/120/160/200/250/300GB PATA 3-11
3.4.1 DC Power (J1, Section A)
The recommended mating connectors for the +5 VDC and +12 VDC
input power are listed in Table 3-3.
Table 3-3 J1 Power Connector, Section A
Note: Labels indicate the pin numbers on the connector. Pins 2
and 3 of section A are the +5 and +12 volt returns and
are connected together on the drive.
3.4.2 External Drive Activity LED
An external drive activity LED may be connected to the DASP-I/O pin 39
on J1. For more details, see the pin description in Table 5-1.
3.4.3 PATA Bus Interface Connector (J1, Section C)
On the Quickview 300 80/100/120/160/200/250/300GB PATA hard
disk drives, the PATA bus interface cable connector (J1, section C) is a
40-pin Universal Header, as shown in Figure 3-5.
To prevent the possibility of incorrect installation, the connector has
been keyed by removing Pin 20. This ensures that a connector cannot
be installed upside down.
See Chapter 5, “PATA Bus Interface and PATA Commands,” for more
detailed information about the required signals. Refer to Table 5-1 for
the pin assignments of the PATA bus connector (J1, section C).
PIN
NUMBER
VOLTAGE
LEVEL
MATING CONNECTOR TYPE AND PART NUMBER
(OR EQUIVALENT)
J1 Section A (4-Pin):
1 +12 VDC 4-Pin Connector:
AMP P/N 1-480424-0
Loose piece contacts:
AMP P/N VS 60619-4
Strip contacts:
AMP P/N VS 61117-4
2 Ground
Return for
+12 VDC
3 Ground
Return for
+5 VDC
4 +5 VDC