MRV Communications EM316-2SFP - Manual (Page 19)

EM316-2SFP User Guide
P/N 1259003-001 Rev C3 10
3.5.2.2 Mylar Tab SFP Modules
The Mylar tab or nail latch on the module has a tab that you must pull in order to remove the
module from a switching module port.
Figure 12 -- Mylar Tab on SFP Module
(3) Inserting a Mylar Tab SFP Module
To insert the Mylar tab SFP module into a switching module port, line up the SFP module
with the port, and slide it into place
Figure 13 -- Insertion of a Mylar Tab SFP Module
(4) Removing a Mylar Tab SFP Module
To remove the SFP module from the switching module port, pull the tab gently until the SFP
module disengages from the port, and then pull the SFP module out.
Figure 14 -- Removal of a Mylar Tab SFP Module
Caution When pulling the tab to remove the SFP module, be sure to pull in a straight
outward motion. Do not twist or forcibly pull the tab because you may disconnect it from the
SFP module.