Master Lock XR20 - Manual (Page 34)

30 XR20 Appendix
The relay activates for
five seconds during which
you must open the door.
Once you open the door,
you have 40 seconds to
exit and close the door
before the zone 2 Soft-
Shunt expires.
Easy Entry™ User's Guide
This section of the user's guide provides information on using the Easy Entry™ access control capability of the security command system. If
your system is not currently using any access control devices, disregard this section. Easy Entry™ is built into every Security Command system
and can be accessed using Easy Entry™ keypads.
There are three different operating modes: Door Strike, Arming and Disarming, and Entry Delay. All of the examples below assume that your
system requires a user code to arm and disarm the protection.
DOOR STRIKE
Area and All/Perimeter Door Strike - From the Status List, present
your card to the reader. Once it is validated by the system, the Door
Strike relay activates. See Door Strike Relay Operation above.
Home/Away systems only activate the Door Strike relay when arming
and disarming.
Select NO to arm or disarm
individual areas. Select YES,
or simply wait, and the
keypad will automatically
arm or disarm all areas for
which you are authorized.
ARMING AND DISARMING AN AREA SYSTEM
Press Command. The keypad displays ARM DISARM.
Press the Select key under either option. The keypad
displays ENTER CODE: -. Present your card to the reader.
Once it is validated by the system, all areas accessible by
you arm or disarm automatically and the Door Strike relay
activates.
ABC SECURITY
FRI 2: 5 1 A M
POWER
While the keypad is in
the Status List, present
your access card.
ABC SECURITY
ARM DISARM ABC SECURITY
ENTER CODE: – ABC SECURITY
ALL? NO YES
POWER POWER POWER
Appendix