Master Lock XR20 - Manual (Page 39)

XR20 Appendix 35
PhoneAccess™ User's Guide
This exciting feature allows you to call your XR20 system from any outside touch-tone phone to arm and disarm protection areas or turn
on or off the panel's relay outputs.
Press To do this You will hear
# then 1 Arm all areas 3 short beeps
# then 2 Arm area 1 1 short beep
# then 3 Arm areas 1 & 2 2 short beeps
Note: Zones in a bad condition are force armed when the area arms.
# then 0 Disarm all areas 1 long beep
#, 5, 4, 0, n* Toggles the output 1 short beep = on
1 long beep = off
4 short beeps = restricted
1. _________________________ 3. _________________________
2. _________________________ 4. _________________________
How it works
1. From a touchtone phone, call the XR20 system's phone number.
2. The XR20 answers and sounds a short ready tone. You now have
8 seconds to enter a valid Master user code. If the user code is
accepted by the panel, you will hear one or more beeps giving you
the current armed status of the system. (You can also find out the
armed status of the system by pressing the * key at any time.)
If You will hear
All areas are armed 3 short beeps
Area 1 (Perimeter) is armed 1 short beep
Any area is armed 2 short beeps
All areas are disarmed 1 long beep
If the user code is not accepted by the panel, you will hear four short
beeps. Check the user code and try again. After 3 unsuccessful
attempts to enter the code, the panel locks out PhoneAccess™ until
a valid user code is entered at a keypad.
3. Once the user code is accepted by the panel and the armed status
is given, you can enter the following commands:
Press To do this You will hear
#, 1 Arm all areas 3 short beeps
#, 2 Arm area 1 1 short beep
#, 3 Arm areas 1 & 2 2 short beeps
#, 0 Disarm all areas* 1 long beep
#, 5, 4, 0, n* Toggles the output 1 short beep = on
1 long beep = off
4 short beeps = restricted
Note: Faulted zones are force armed when the area arms.
Quick Reference Wallet Card
(* Use outputs 1, 2, 3, or 4 in place of n)
Press To do this You will hear
# then 1 Arm all areas 3 short beeps
# then 2 Arm area 1 1 short beep
# then 3 Arm areas 1 & 2 2 short beeps
Note: Zones in a bad condition are force armed when the area arms.
# then 0 Disarm all areas 1 long beep
#, 5, 4, 0, n* Toggles the output 1 short beep = on
1 long beep = off
4 short beeps = restricted
1. _________________________ 3. _________________________
2. _________________________ 4. _________________________
(* Use outputs 1, 2, 3, or 4 in place of n)
(Enter output descriptions below)
(* Use outputs 1, 2, 3, or 4 in place of n)
(Enter output descriptions below)
Cut along dotted lines
PhoneAccess™ Quick Commands
PhoneAccess™ Quick Commands