5 disarm, Disarm, Figure 49 - disarm installation – Motorola PTP 400 Series User Manual
Page 107
Advertising
105
If all the settings are correct and appropriate click the “Confirm Configuration and Reboot
Unit” button. All the attributes are committed to non-volatile memory. Immediately following
the write to non-volatile memory the unit is reset.
Note:
If you have changed the Ethernet parameters you must reconnect using the correct
network and address settings.
If the installer wishes to modify the installation configuration then the ‘Back’ link can be used
to access the installation wizard steps described above.
8.3.5.5 Disarm
The next step of the installation wizard is the Disarm Phase.
Figure 49 - Disarm Installation.
Advertising