Monessen Hearth TPB18 - Manual (Page 23)

70D0004 23
LOG PLACEMENT
Figure 19 - Installing Rear Log (#1)
Before you begin — This unit is supplied with seven (7) ceramic fiber logs. Do not handle these logs with your
bare hands. Always wear gloves to prevent skin irritation from ceramic fibers. After handling the logs, wash
your hands gently with soap and water to remove any traces of fibers.
INSTALLING CHARRED TIMBER LOGS ON
BURNER
W
ARNING
The positioning of the logs is critical to the safe and clean operation of this heater. Sooting and
other problems may result if the logs are not properly and firmly positioned in the appliance.
Never add additional logs or embellishments such as pine cones, vermiculite or rock wool to
the heater. Only use the logs and TPB18-RW (rock wool) supplied with the unit.
Failure to position the parts in accordance with diagrams below or to use only parts specifically
approved for this heater may result in property damage or personal injury.
Figure 20 - Installing Right Base
Log (#2)
Pins
Rear Log (#1)
1. Place rear log (#1) on two
pins located on the back of
the grate. see Figure 19.
2. Place right base log (#2) on two
pins on right side of grate.
see Figure 20.
Pins
Right Base Log (#2)