Monessen Hearth TPB18 - Manual (Page 31)

70D0004 31
Figure 36 - Location of Piezo Ignitor, Control Knobs and Switch
A. This appliance is equipped with a piezo ignition device which lights the pilot. If piezo is not working properly
see Match lighting instructions, page 33.
B. BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
• Do not attempt to light any appliance.
• Do not touch any electric switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to push in, or turn the gas control knob. Never use tools. If the knob will not push in or
turn by hand, don't try to repair it. Call a qualified service technician. Force or attempted repair may result in
a fire or explosion.
D. Do not use this appliance if any part of it has been under water. Immediately call a qualified service techni-
cian to inspect the appliance and to replace any part of the control system and any gas control that has been
under water.
OPERATING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
W
ARNING
If you do not follow these instruction
exactly, a fire or explosion may result
causing property damage, personal
injury or loss of life.
Piezo
Ignitor
Pilot
Switch
Hi/Lo Knob
On/Off/Pilot
Knob