Magellan GLOBAL SATELLITE TELEPHONE - Manual (Page 49)

WorldPhone – Chapter 2. Operation 2.25
M e n u M e n u M e n u Data/printer port setup cont’d
Data/printer port setup cont’d
Hot dial:
When enabled, this function monitors the DTR-pin on the DATA port.
When the DTR-pin is pulled high by equipment connected to the
DATA port, a data call is automatically initiated to a pre-programmed
number. The number is automatically stored under short number 99.
9
Scroll down to
Hot Dial:
10
Setup opens the
Phone book editing
window.
Enter name, f.ex. "Hot".
Fill in required number,
and change provider
and network, if needed.
Initial mode:
The mode is set to AT modem as default.
With a PC running a terminal program connected to the WorldPhone
(f.ex. Windows HyperTerminal), the menu is displayed on the screen.
When selecting any of the MMI (Man Machine Interface) settings, the
PC screen automatically displays the WorldPhone picture.
11
Scroll down to Initial mode (step 9).
Pressing Selct
allows choosing
MMI interface:
12
Save stores the chosen settings.
470 SIM
470 SIM
Setup Enab Disab Save
3 – Data/printer port setup
Bit rate: 9600 bps
Printer : Disabled
AT modem: Disabled
Hot Dial: Enabled
Initial mode: AT modem
Setup Enab Disab Save
3 – Data/printer port setup
Bit rate: 9600 bps
Printer : Disabled
AT modem: Disabled
Hot Dial: Enabled
Initial mode: AT modem
Del ´ Save
Edit mode in Phone book
Name : Hot
Number : 004766779016
Net provider: Default Net
Terrestrial network: 00
Hot dial
470 SIM
Selct
3 – Data/printer port setup
Bit rate: 9600 bps
Printer : Disabled
AT modem: Disabled
Hot Dial: Enabled
Initial mode: AT modem
Initial mode
AT modem
MMI (ASCII)
MMI (extended ANSI)
MMI (multilingual)
470 SIM