MITSUBISHI ELECTRIC WD-52627 - Manual (Page 12)

12
Chapter 1. Television Overview
Front Control Panel
The shaded buttons on the front control panel are duplicated on the remote control. The top row of labels shows the
control functions when there are no TV menus displayed on the screen. The bottom row of labels shows the control
functions when the TV menus are displayed on the screen or when a special function has been activated. See
“Remote Control Overview” for further details on the functions of these buttons.
<
DEVICE GUIDE
CANCEL MENU ENTER
MENU FORMAT – CH – < >
ADJUST
– VOL – < >
> < >
POWER
SYSTEM
RESET LAMP STATUS TIMER
System Reset
If the TV does not respond to either the remote control or the front panel controls and/or
does not power Off, press the SYSTEM RESET button with a pointed item like the end
point of a paperclip. The TV will turn Off and the TIMER light will flash quickly for about
one minute. When the TIMER light stops flashing, you may again turn on the TV. The
changes you made the last time the TV was on before you used the SYSTEM RESET
button may be lost; any changes that were previously saved are not lost, however.
<
DEVICE GUIDE
CANCEL MENU ENTER
MENU FORMAT – CH – < >
ADJUST
– VOL – < >
> < >
POWER
SYSTEM
RESET LAMP STATUS TIMER
A/V Reset
There may be times when you wish to reset the A/V (Audio and Video) settings back to the factory defaults. To
return all of the settings at once, press GUIDE and FORMAT on the front panel at the same time. To reset the
defaults for individual devices, use the A/V Memory Reset selection on the Audio/Video menu.
<
DEVICE GUIDE
CANCEL MENU ENTER
MENU FORMAT – CH – < >
ADJUST
– VOL – < >
> < >
POWER
SYSTEM
RESET LAMP STATUS TIMER
Front-Panel Indicator Lights
Power/Timer Indicator
Indicator Color TV Condition Additional Information
None (indicator
off) TV is powered OFF. Normal operation.
Green, steady TV is powered ON. Normal operation.
Green, rapid
blinking 1. TV just plugged into AC outlet. Wait until blinking stops before turning on
(approximately 1 minute). Normal operation.
2. AC just restored after power failure. Wait until blinking stops before turning on
(approximately 1 minute). Normal operation.
3. TV Rebooting after System Reset
used.
Wait until blinking stops before turning on
(approximately 1-2 minutes). Normal operation.
4. TV Rebooting after power
fluctuation or receiving abnormal
digital signals from digital channel,
CableCARD™, or digital device.
Wait until blinking stops before turning on
(approximately 1 minute). Normal operation.
5. You have begun the procedure to
update software from an authorized
flash memory device.
For detailed information, see the instructions
that accompany the authorized software update.
Important: Do not use non-authorized software at
any time.
Green, slow
blinking TV powered off and automatic-on
timer is set. Normal operation. TV can be turned on at any
time.