MITSUBISHI ELECTRIC WD-52627 - Manual (Page 77)

Chapter 5. TV Menu Screen Operations
77
Audio/Video
Figure 24
Figure 24. Audio/Video Menu, Settings
A/V Memory Reset
A/V Memory Reset allows you to select the device which
will have the A/V Settings returned to the original factory
settings. To return a device’s memory to the original
factory settings, select the device and then press ENTER.
Settings
Each device has its own A/V memory. Select the device
in A/V Memory Reset, then select Audio or Video to
adjust the device’s individual settings. Press ENTER,
and the menu is removed and the individual settings are
displayed.
Use ADJUST or to select the individual settings
to be adjusted. Use ADJUST or to make the
adjustment. For descriptions of the individual A/V
settings see A/V Setting Descriptions, pages 78 and 79.
Video Mute
Video Mute lets you display a blue background when no
signal is being received on Inputs 1–3 and COMPONENT
1–3.
Film Mode
Auto is the default setting and will automatically detect
and apply film decoding correction for signals that
originated on 24 frames per second film cameras and
then were converted for broadcast to 30 frames per
second video.
When the original signals originated on 30 frames per
second video cameras, the Auto setting will automatically
apply video decoding, the same as used with the Off
setting. Try the Off setting when the TV seems to have
difficulties and adds too many jagged edges to the
images.
Film Mode is not effective for high definition signals.
Audio/Video Menu
Using the AUDIO or VIDEO Button on
the Remote Control
To adjust individual Audio or Video settings directly with
the remote control:
1. Press AUDIO or VIDEO to cycle through the available
settings.
2. Press ADJUST or to adjust the setting. After
5 seconds of inactivity, the setting display will
disappear.
TV Speakers
When an A/V receiver has not been set up in
NetCommand, this selection will turn the TV’s internal
speakers on or off. You may select Off when sending
the sound through a separate stereo system or surround
sound A/V receiver.
This option is unavailable (grayed out) when
NetCommand
®
is enabled and you have selected the A/V
receiver icon from the Device Selection menu. In that
case, Netcommand automatically turns the TV speakers
off. See the NetCommand information for further
instructions.
Note: To prevent damage from a sudden increase in
volume, make sure the TV volume is set to low before
setting speakers to On.