MITSUBISHI ELECTRIC WD-52627 - Manual (Page 74)

7
Chapter 5. TV Menu Screen Operations
V-Chip Lock Menu
To view a V-Chip blocked program or to watch the
program during a scheduled lock time, you must enter
your four-digit pass code or change the channel to an
unlocked program. Once you have entered the pass
code, the V-Chip block for that channel or Lock by Time
will remain released until the TV is powered Off and then
On again.
Channel is locked.
V-Chip locked the program because the rating is
TV-PG DSLV
To watch the program, Enter your passcode.
– – – –
Use the NUMBER buttons and press ENTER.
Figure 21. V-Chip pass code screen
V-Chip
Select V-Chip Lock to perform the functions listed below.
V-Chip allows you to Block or Allow programs based
upon rating signals sent by the broadcaster. The TV
comes from the factory with the V-Chip Lock in the Off
setting.
You can turn the V-Chip on within the V-Chip Menu or
you can use the V-CHIP button on the remote control to
conveniently turn the V-CHIP on or off.
The factory preset is TV-PG for TV ratings or PG for
movie ratings, allowing only programs rated TV-PG/PG
or lower. You can change the blocking level to various
TV ratings and lettered categories or movie ratings. After
changing channels or devices, there may be up to a 5
second delay before the V-Chip lock takes effect.
Entry
Figures 20 and 21
You will see the screen shown in Figure 20 when you
press V-CHIP on the remote control, the first time you
select the V-Chip Lock menu, or after you have canceled
your pass code. To use the Lock, input a four-digit pass
code with the number buttons on the remote control, then
press ENTER. You can delete a number and move back
one space by pressing CANCEL. You can exit without
inputting a pass code by pressing MENU or HOME.
After setting a pass code, the V-Chip Lock is active. The
next time you select V-Chip Lock you will see “...enter
your pass code” instead of “...enter a new pass code.”
V-CHIP is OFF.
The rating is set to
TV-PG
To turn V-Chip on, enter new passcode.
– – – –
Use the NUMBER buttons and press ENTER.
Figure 20. V-Chip Entry screen
V-Chip Start Time and V-Chip Stop
Time
Figure 22
Select the times you would like the V-Chip to be active.
By setting the V-Chip Start Time and V-Chip Stop Time to
the same time, the V-Chip will be active 24 hours a day.
Press ADJUST or to slowly select the time, starting
with the hours. Press and hold ADJUST or to
quickly select the hours, press ADJUST to select the
minutes.
Figure 22. V-Chip Menu, Start & Stop Time
If you forget your four-digit Pass code,
see Appendix A.
IMPORTANT