Mitel 5603 - Manual (Page 56)

5603 Wireless Handset User Guide
50
The easy replacement procedure is done via the handset display and the 5603/4 Programmer
or the 5603/4 Rack Charger.
The following settings are replaced during easy replacement:
• DECT registration
• User parameters (including User ID)
• Contacts
• The extension number is assigned to the new handset.
The following settings are not replaced during the easy replacement:
• Call list
Before Starting Easy Replacement Procedure
1. Check that both the old handset (that is, the handset to be replaced) and the new handset
(that is, the replacement handset) are of the same device type (5603).
2. Make sure that the handset batteries are charged before starting the easy replacement
procedure.
3. Switch off the new handset by long pressing .
Easy Replacement Procedure
During the Easy Replacement procedure, the LEDs of the handset and the charger follow the
same LED indications. This means that if the old handset has a broken display, the LED
indications on the charger and on the handset can be used to follow the replacement procedure.
Before and after easy replacement, the LEDs may have different LED indications. For more
details, see also“LED Indications during Easy Replacement” on page 52.
IMPORTANT:Never remove a handset from the charger until the instructions in the
display or the LED tells you to do so (see status on the LED if the display is broken). If
there is an error indication, it may be allowed to remove the handset, see
“Troubleshooting” on page 45 for further instructions.
After the old handset has been in the charger, the new handset needs to be placed in
the charger regardless if the replacement was successful or not. Failing to do so may
result in malfunction and the new handset will need to be sent for service.
Note: It is possible to perform Easy Replacement between different product licenses
(that is; Basic and Advanced). The new handset’s product license is not replaced by the
old handset’s variant license during the procedure
1
.