Mitel 5603 User Manual
Page 57
5603 Wireless Handset User Guide
51
Figure 10: Easy Replacement Procedure via the 5603/4 Programmer
I
1
On the new handset, press and hold
Note: Do not release
until you are instructed to do so.
2
Put the new handset in the charger.
3
When the text "Start phone replacement?" is displayed, release
.
Press "Yes" (left soft key).
The text "Follow the instructions. Each step can take several minutes." appears in the display.
Press "OK"(left soft key).
4, 5
When the text "Please insert old phone in charger" is displayed, replace the new handset with
the old handset. The handset can either be switched on or off.
Note: If the 5603/4 Rack Charger is used, the same charging slot has to be used for both
handsets.
The handset will be restarted and after a few seconds, the text "Saving settings. Do not remove
phone from charger" appears. The charger LED changes to slow orange flashing.
IMPORTANT: Do not remove the handset while the text "Saving settings. Do not remove phone
from charger" is displayed. It may take several minutes
6, 7
When the text "Please insert new phone in charger" is displayed, replace the old handset with
the new handset. The text "Restoring settings" is displayed.
IMPORTANT: Do not remove the handset while the text "Restoring settings" is displayed.
8
When the text "Phone successfully replaced. Please remove phone to restart." appears in the
display, remove the handset from the charger. The handset is automatically restarted.
1
2
3
New
New
Old
New
4, 8
5
6
7