Motorola LS3578 - Manual (Page 171)

Chapter 11 Symbologies
Introduction
This chapter describes symbology features and provides the programming bar codes for selecting these features
for the scanner. Before programming, follow the instructions in
Chapter 1, Getting Started .
The scanner is shipped with the settings shown in the Symbology Default Table on page 11-2 (also see Appendix
A, Standard Default Parameters for all host device and miscellaneous scanner defaults). If the default values suit
requirements, programming is not necessary. Set feature values by scanning single bar codes or short bar code
sequences. To return all features to default values, scan the
Default Parameters on page 5-4 .
If not using a Synapse or USB cable, select the host type (see the specific host chapter) after the scanner emits
power-up beeps.
Scanning Sequence Examples
In most cases, scan only one bar code to set a parameter value. For example, to transmit bar code data without the
UPC-A check digit, scan the
Do Not Transmit UPC-A Check Digit bar code under Transmit UPC-A/UPC-E/UPC-E1
Check Digit on page 11-12 . The scanner issues a fast warble beep and the LED turns green, indicating a
successful parameter entry.
Other parameters, such as Set Length(s) for D 2 of 5 require scanning several bar codes in sequence. See the
parameter description for this procedure.
Errors While Scanning
Unless otherwise specified, if an error is made during a scanning sequence, re-scan the correct parameter.