Motorola LS3578 - Manual (Page 47)

Radio Communications 4 - 3
Wireless Beeper Definitions
When the scanner scans the pairing bar code it issues various beep sequences indicating successful or
unsuccessful operations. See
Table 4-2 for beep sequences that occur during pairing operations.
Authentication Disable 4-27
Variable Pin Code Static 4-28
Encryption Disable 4-29
Table 4-1 Radio Communication Default Table (Continued)
Parameter Default
Page
Number
Table 4-2 Wireless Beeper Definitions
Beeper Sequence Indication
Short low-high beeps Scanner has paired with the cradle.
Short high-low beeps Scanner has unpaired with the cradle.
Note: When connected to a remote device using SPP or HID, if a
disconnect beep sequence sounds immediately after scanning a
bar code, check the host device to determine if it received the
transmitted data. The scanner may have transmitted the last bar
code scanned after losing the connection.
Long low-long high beeps Unsuccessful pairing attempt. See Auto-reconnect Feature on
page 4-15 .
Long low-long high-long low-long high
beeps Remote device rejected connection attempt, possibly due to an
attempt to pair with a cradle that is already paired with the
maximum number of scanners.
Four long low beeps 1. A transmission error was detected in a scanned symbol. The
data is ignored. This occurs if a unit is not properly configured.
Check option setting.
2. When communicating with a cradle, the cradle acknowledges
receipt of data. If the acknowledgment is not received, this
transmission error beep sequence sounds. Data may still have
been received by the host. Check the host system for receipt of
transmitted data. If data was not received by the host, re-scan the
bar code.
Five high beeps Emitted every 5 seconds while a reconnection attempt is in
progress. See
Auto-reconnect Feature on page 4-15 .