Motorola LS3578 - Manual (Page 75)

Chapter 5 User Preferences
Introduction
This chapter describes each user preference feature and provides the programming bar codes for selecting these
features for the scanner.
The scanner ships with the settings shown in the User Preferences Default Table on page 5-2 (also see Appendix
A, Standard Default Parameters for all host device and miscellaneous scanner defaults). If the default values suit
the requirements, programming is not necessary.
Set feature values by scanning single bar codes or short bar code sequences. The settings are stored in
non-volatile memory and are preserved when the scanner powers down.
The scanner communicates with the host through the cradle. During scanner setup, the scanner is paired with a
cradle, which is connected to the host through one of several interfaces (see
Pairing on page 1-10 and the
applicable host interface chapter). Each cradle can pair with up to four scanners.
If not using a Synapse or USB cable, select the host type (see the specific host chapter) after the scanner emits
power-up beeps. This is only done upon the first power-up when connecting to a new host.
To return all features to their default values, scan a Default Parameters bar code on page 5-4 . Throughout the
programming bar code menus, default values are indicated with asterisks (
*
).
NOTE Disconnect the power supply before changing host cables or the scanner may not recognize the new host.
*
High Frequency Feature/Option * Indicates Default