Motorola LS3578 - Manual (Page 83)

User Preferences 5 - 9
Aim Duration
When the scanner is in Level trigger mode (default mode), Aim Duration sets the amount of time the aiming dot
appears before turning into a scanning beam. This parameter has no affect when the scanner is in either of the
Two Stage trigger modes. See
Trigger Mode on page 5-8 for a description of each of the trigger modes.
The aim duration is programmable in 0.1 second increments, from 0.0 to 9.9 seconds. The default Aim Duration is
0.0 seconds. When set to 0.0 seconds, no aiming pattern appears before a decode session.
To set an aim duration, scan the bar code below. Then scan two numeric bar codes from Appendix D, Numeric Bar
Codes that correspond to the desired aim duration. Include a leading zero for durations less than 1.0 seconds. For
example, to set an aim duration of 0.5 seconds, scan the bar code below followed by the 0 and the 5 bar codes. To
correct an error or change the selection, scan Cancel on
page D-3 .
Aim Duration
Beep on Insertion
When a scanner is inserted into a cradle and detects power, it emits a short low beep by default. To enable or
disable beeping on insertion, scan the appropriate bar code below.
*Enable Beep on Insertion
Disable Beep on Insertion