Maxon Telecom WL7-VERS. C - Manual (Page 24)

PATENTS PENDING 24
11921 Slauson
A
ve. Santa Fe Springs, CA. 90670 (800) 227-41
16 F
AX (888) 771-7713
9. Check under the vehicle fl oor for possible in-
terference between the Lift base plate mount-
ing bolts and the vehicle underbody. For
example, check subframe members, wiring
harnesses, cables, and fl uid lines.
PREPARING AND POSITIONING THE LIFT - Continued
7. Remove lifting device and close wheelchair door.
Enter the vehicle. Verify the wheelchair door
closes correctly and the minimum clearance is
3/4”. If door will not close correctly, reposition the
Lift.
5. Using an appropriate lifting device that
can safely lift 500 pounds, raise Lift to the
wheelchair doorway. Place the Lift inside
doorway (FIG. 24-1). Align outboard
edge of Lift threshold plate parallel with
outboard edge of doorway. The decal on
the underside of the Lift platform must
face outboard (FIG. 24-1).
8. Secure vehicle door wide open (FIG. 24-1).
6. Position the Lift according to the clearance di-
mensions given in VEHICLE REQUIREMENTS
section in this Installation Manual.
NOTE: You may use a template instead of the
Lift for positioning the Lift on vehicle. To
use a template, refer to USING TEM
PLATE TO POSITION LIFT section in
this Installation Manual.
VEHICLE RH SIDE VIEW
FIG. 24-1
WHEELCHAIR
LIFT
DECAL (FACES
OUTBOARD)
DOOR