Meridian America 598 - Manual (Page 71)

Configuring the DVD player
64
To configure the sources
If you are using the 598 DVD Audio Player as the controller in
your Meridian system, you can use the Source config option on
the Meridian Setup menu to configure each of the sources in
your system.
● Highlight Source config in the Meridian Setup menu, and
press Enter.
The Source configuration menu is displayed:
For each source you want to configure:
● Press the source key on the remote corresponding to the
source you want to configure.
The Category, Address, and SCART switch options show the
current values defined for that source. The SCART switch
option only appears with the SCART version of the 598.
To change any option:
● Highlight the corresponding option in the Source
configuration menu and press Enter, select the value you
want to use, and press Enter to select it.
The Category identifies the type of Meridian product selected
by the corresponding source. Specify -C for the current product,
1C for a Meridian CD player, 2C for a Meridian tuner, 3C for
another Meridian DVD player, or NC for a non Meridian product
such as a TV.
Normally the Address should be set to 1A. However if you have
more than one Meridian product of the same type in your
system you can use different source keys to select between
them by assigning them different addresses. For example if you
have two Meridian DVD players, assign one of them address 1A
and the other address 2A.
For information about using the SCART switch option see To
set up SCART switching, page 44.