Microsoft MN-130 - Manual (Page 50)

46 Microsoft Broadband Networking PCI Adapter User’s Guide
Regulatory Information
United States Radio and TV Interference Regulations
This device complies with Part 15 of the U.S. Federal Communications Commission (FCC) rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
The Microsoft hardware device(s) that accompanies this software can radiate radio frequency (RF) energy. If not installed and
used in strict accordance with the instructions given in the printed documentation and software Help file, the device may
cause harmful interference with other radio-communications devices (for example AM/FM radios, televisions, baby monitors,
cordless phones, etc.). Any cable that is connected to the device must be a shielded cable that is properly grounded. There is,
however, no guarantee that RF interference will not occur in a particular installation.
Your Microsoft hardware device has been tested, and it complies with the limits for a Class B digital device in accordance
with the specifications in Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful RF interference in a residential installation.
To determine if your hardware device is causing interference to other radio-communications devices, disconnect the device
from your computer. If the interference stops, it was probably caused by the device. If the interference continues after you
disconnect the hardware device, turn the computer off and then on again. If the interference stopped when the computer
was off, check to see if one of the input/output (I/O) devices or one of the computer’s internal accessory boards is causing
the problem. Disconnect the I/O devices one at a time and see if the interference stops.
If this hardware device does cause interference, try the following measures to correct it:
• Relocate the antenna of the other radio-communications device (for example AM/FM Radios, televisions, baby
monitors, cordless phones, etc.) until the interference stops.
• Move the hardware device farther away from the radio or TV, or move it to one side or the other of the radio or TV.
• Plug the computer into a different power outlet so that the hardware device and radio or TV are on different circuits
controlled by different circuit breakers or fuses.
• If necessary, ask your computer dealer or an experienced radio-TV technician for more suggestions. You may find
helpful information in the booklet “The Interference Handbook” (1995), published by the FCC. The booklet is available
from the FCC at 1-888-CALL FCC or at http://www.fcc.gov/cib/Publications/tvibook.html.
Note
Any changes or modifications not expressly approved by Microsoft could void the user’s authority to operate this device.
For use with UL Listed and GS approved personal computers.
Not intended for use in machinery or industrial applications.
Tested to comply with FCC standards. For home and office use. Model Number: MN-100, MN-110, MN-120, MN-130, MN-
150, MN-500, MN-510, MN-520.
Microsoft Corporation
One Microsoft Way
Redmond, WA 98052-6399.
(800) 426-9400 (United States)
(800) 933-4750 (Canada)
Canadian Radiocommunication Regulations
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.