Microsoft ET180 - Manual (Page 32)

1 G e t t i n g t o k n o w y o u r E T 1 8 0
Peripherals tour
12
Headset operation
The table below describes the action of the Send/End button on the headset when
there’s an active mobile phone connection. When there’s no active mobile phone
connection or when the Phone application is turned off, the headset’s Send/End button is
disabled.
Keypad module
The detachable keypad module let’s you enjoy the one-hand operation of using
conventional mobile phones for dialing and composing SMS messages.
The module has the following dimensions—63 mm x 60.3 x 3.5 mm (length x width x
depth), with a 240 x 144 resolution rate. For your convenience, the keypad is illuminated
in dim lighting conditions.
NOTE: The keypad module is not included in the ET180 package contents; you need to purchase
this item separately.
To attach the keypad module to the device
1 Remove the callpad module from the device by sliding it in a downward motion.
2 Insert then press down the keypad module into its bay until it clicks into place.
The module connector (i.e., gold bars) underneath the module should be aligned
to its corresponding connector on the device bay.
Scenario
Action
Quick Press Press and hold for > 2 sec.
Incoming call Accept the call Accept the call
Ongoing call Terminate the call Record the ongoing call