Micron Technology Transport LT - Manual (Page 35)

Using the Floppy Drive Introducing Your TransPort LT
35
To start the SmartBay utility:
1. Click the Start button on the Windows taskbar.
2. Select SmartBay Hotswap Utility .
To remove a device:
1. Open the SmartBay Hotswap Utility.
2. Select Remove Device and click OK.
3. Click Yes on the confirmation screen
4. Remove the device by either disconnecting the cable from the computer or
from the device.
5. Click OK.
To insert a device:
1. Open the SmartBay Hotswap Utility.
2. Select Insert Device and click OK.
3. Connect the device to the computer using the device cable. Make sure all
connectors are correctly attached.
4. Click OK to allow your computer to detect the device.
If the computer does not detect the device, remove the device and re-install it.
Make sure to pay careful attention to the procedures to insure the device is
installed correctly.
Using the Floppy Drive Your computer comes with a 1.44 MB, 3.5-inch, high-density floppy drive, which
can read, write to, and format the following disks:
• A high-density, 3.5-inch disk, which stores 1.44 MB (megabytes) of data.
• A double-density, 3.5-inch disk, which stores 720 KB (kilobytes) of data.
N OTE : The floppy drive in your notebook computer is smaller, but more power-efficient,
than a floppy drive in a desktop computer. To get the best performance from your
floppy drive use high-quality floppy disks, such as those available at http://www.e-
additions.com.
The computer is shipped from the factory with both a floppy drive and a CD-ROM
or DVD-ROM drive included.