Micron Technology Transport LT - Manual (Page 43)

Using the Battery Introducing Your TransPort LT
43
2. Close the LCD panel, and turn the
computer over so that the bottom of
the unit faces up.
3. Push down the battery latch and
hold it, then pull the battery pack
from the computer. (Figure 16)
Figure 16. Removing the Battery Pack
Installing the Battery To install the battery pack:
1. With the computer’s power off, close the LCD panel and turn the computer
over so the bottom of the unit faces up.
2. Slide the battery pack into the compartment. Make sure the battery is fully
inserted into the compartment.
Figure 17. Installing the Battery
C AUTION : Insert the battery into the battery compartment, ensuring the correct
orientation so that the battery fits in its slot properly.
Monitoring the Battery Charge Battery life is effected by factors such as the power-management settings in
System Setup, the applications you use, and the brightness settings of the LCD.
Under normal usage, the battery charge lasts approximately two and a half hours.
N OTE : Battery life estimates are subject to variation. The actual life of your battery may
be less than the estimates given in this manual.