Motorola XTNID - Manual (Page 47)

45 English
PROG
RAMM
ING
FEATUR
ES
on the display, indicating that you can choose
your setting. To set the channel number, press
the
/ buttons until you reach the
desired channel number. Once you have
selected the channel, proceed to enable
("YES") or disable ("NO") the scan feature by
toggling the SB2 (*) button. Once you have set
the values you need, long press the PTT
button to save an exit.
Note: (*)This assumes the SB2 button is not being
programmed for a different mode.
Note: If the MAX CHAN setting in the radio is set to
1, the Scan Programming option will not
show (will be disabled).
PROGRAMMING BUTTONS
You can map any channel to either button B or
C as a preset channel. To enable, enter
’Programming Mode’ and choose the channel
you want to set as preset channel using the
/ buttons. Once you have selected
your channel, press and hold the B or C button
for 2-3 seconds.
A short press of either preset button (B and C)
will play a good key chirp. When scanning, a
short press of either preset button will change
the home channel to the preset channel. The
radio will display FREQ/PL and will continue to
scan from the new home channel.