Madrigal Imaging MP-9 - Manual (Page 7)

Section 2
Installation & Setup
This section explains how to install and set up the projector. If you are familiar with the projector and want
to quickly set it up for temporary use, follow the Quick Setup instructions in section 2.1. For a complete
setup, skip section 2.1 and follow the instructions and guides covered in the remaining subsections.
2.1 Quick Setup Follow these 7 steps for quick set up of the projector:
Step 1
➤
Position the Projector
To perform a quick setup, the projector must be positioned so that the throw
distance is the same as that used during the most recent optical alignment;
otherwise a detailed setup is required. The throw distance is the distance
between the center lens on the projector and the center of the projection
screen. See Appendix F and Appendix G for more information. Note: If an
optical lens alignment is required, refer to section 2.8, Optical Alignment.
Step 2
➤
Connect the Power Cord
Plug the AC line cord into the line input unit on the lower front panel of
the projector. Plug the three prong end of the line cord in a grounded AC
outlet. Notes: 1) Input voltage must be between 90 VAC and 264 VAC.
2) Ensure the line cord is the proper type for the AC receptacle.
Step 3
➤
Connect a Source
Connect a source to the projector’s RGB input. Ensure the source is on and
properly connected.
Step 4
➤
Access the Keypad
Remove the projector’s front top cover to access the keypad. See page 3-2.
Step 5
➤
Turn the Projector On
Press on the keypad to turn the projector on. Hold down the power
key for about one second. Note: If the keypad has been configured for IR
remote operation, point it towards the screen or the front of the projector.
POWER
2.1