Madrigal Imaging MP-9 - Manual (Page 90)

To program or modify an event, first use the arrow keys to move the cursor
to the field you want to modify (for example, the Type field). Next use
and/or the number keys to modify that field. Details for field modification are
provided on the following pages. Modify each field in the row as necessary
making sure all fields for the event are valid and logical.
When all modifications have been made, press
to display the Exit dialog box. When the
Exit box is first displayed the cursor bar is
positioned on “Save.” Press
or to
save the new changes. To return to the Programmable Events feature
box, move the cursor bar to “Continue Change” then press
. To
discard your changes, move the cursor bar to “No Save” then press
or
. returns you to the Clock/Events menu. returns you to
operation level.
The Type Field
The Type field shows the event to take place. With the cursor positioned on
the Type field press
to cycle through the available events. Press to
clear the entire event line. Events are described in Table 3-1 below.
Table 3-1. Type Field Events
* Only valid entries are accepted.
EVENT DESCRIPTION NOTES
No programmed event.
Turn Standby mode on.
Turn Standby mode off.
Turn Power off.
Select a channel from the Channel List.
Select an input.
Perform an ACON (full) auto-convergence.
Perform an ACON (touchup) auto-convergence.
Perform an ACON (center only)
auto-convergence.
Switch to the next available channel from the
Channel List.
Switch to the prior available channel from the
Channel List.
Perform a warm-up sequence:
1) Turn Standby mode off (if on).
2) Set Contrast to 20%, Brightness to 50%,
HSize to 80%, VSize to 80% and master
static focus to 100%
3) Display white field for 15 min.
4) Restore original display settings.
* Use the number keys to enter
the channel #.
* Use the number keys to enter
the switcher # and slot #.
ACON module is required.
ACON module is required.
ACON module is required.
Cycles back to the first channel
after last channel is selected.
Cycles back to the last channel
after the first channel is selected.
Exit from warm-up occurs after
15 minutes or when the EXIT key
is pressed. Other keys which
stop warm-up are PROJ, *, UTIL,
CONV and RECALL. When
warm-up stops, all original
display settings are restored.
None
Standby On
Standby Off
Power Off
Channel selection
Source selection
ACON (Full)
ACON (Touchup)
ACON
(Center Only)
Channels Up
Channels Down
Warmup
ENTER
EXIT ENTER EXIT
ENTER
ENTER
EXIT ENTER
EXIT
ENTER
OPERATION
3.48