2 cleaning, 3 trouble- shooting – Madrigal Imaging MP-9 User Manual

Page 97

Advertising
background image

In rare instances, flashing lights can trigger an epileptic seizure. During
ACON usage persons with epilepsy should look away from the screen.

4.2 Cleaning

Clean the projector when required. Before cleaning, always unplug the
projector from the power outlet.

Lens Cleaning

To avoid the risk of scratching the lenses, only clean the lenses if absolutely
required. A small amount of dust on the lenses will have very little effect on
picture quality. If the lenses must be cleaned, use a DRY soft cotton cloth.
Rub gently in a circular motion.

Case Cleaning

Clean the case with a soft dampened cloth. Use a mild commercial cleaner.
Do not use liquid or aerosol cleaners.

ACON Cleaning

The lens on the ACON Locator Assembly is very tolerant to dust and
should only be cleaned if ACON performance is affected. Cleaning of the
lens (if required) must be performed with great care. Use a DRY soft cotton
cloth. Rub gently in a circular motion.

4.3 Trouble-

shooting

If the projector is not operating properly, note the symptoms of the problem
and use the following guide to assist you. If you cannot resolve the problem
yourself, contact your dealer for assistance.

Projector Response

Problems

Refer to the following if the projector is not responding to keypad commands.

Symptom:

The projector will not turn on when

is pressed. All back panel

lights are off. See Figure 4-1.

Cause/Remedy:

1) The power cord may be dis-

connected. Check the power
cord connection at the wall
outlet and the projector.

Figure 4-1. Rear Panel LEDs

Symptom:

The projector will not turn on when

is pressed. Only the amber

LED on the back panel is lit.

Cause/Remedy:

1)

may not have been held down long enough to initiate projector

power-up. Hold down

for at least one second to initiate power-up.

2) If using an IR keypad, ensure it is pointed at the screen or the front of

the projector. If the keypad is configured for built-in or wired usage,
make sure it is properly connected to the projector.

POWER

POWER

POWER

POWER

CON

CON

MAINTENANCE

4.3

Advertising