Madrigal Imaging MP-9 - Manual (Page 83)

The Name Field
The Name field stores the names of the sources in the list. Source names
may be up to 11 characters in length. It is recommended that source names
be entered to make it easier to keep track of the sources. Source names are
briefly displayed when channels are selected.
Notes: 1) Digits may be entered using the number keys on the keypad or selected
using the
and keys. 2) If is pressed during name editing, all characters in
the field to the right of the cursor will be cleared.
The Input Field
The Input field contains the switcher and slot number of the input to be
switched to when the channel is selected. If the input is a direct projector
input, the input number is a 0 followed by the projector slot number. If
the input is from a switcher, the input number is a number from 1 to 9
(switcher number) followed by the switcher slot number.
The Recall Memory Field
The Recall Memory field contains the number of the Recall memory to be
used when the channel is selected. If the field does not contain a number
(a blank or dash is shown), no Recall memory will be used.
The Up/Down Field (U/D)
The Up/Down field specifies the channels which are accessible when using
up/down channel selection (explained in section 3.3). If the field does not
contain a check mark, the channel is ignored. To enter a check mark, press a
number key (0-9). To clear a check mark, press
.
Note: Channels should contain valid inputs. For example, do not specify
switcher 1 if switcher 1 does not exist in the system.
Recall Memories
➤
(Listing)
The Recall Memories utility provides a list of the Recall memories stored in
the projector. (Recall memories are explained in section 3.4). The list
includes the scan frequencies of each Recall memory. A check mark (
) is
displayed in the ASR column next to the memories which ASR may use. If
two or more Recall memories have identical scan frequencies, only the
memory last adjusted will have a check mark.
OPERATION
3.41