Microtek Artix Scan1100 - Manual (Page 34)

30 ArtixScan 1100 Hardware User’s Guide
English
11. Reference Section for Macintosh
This section describes the features and commands of the Microtek Scanner ICC Profiler program. All features are
covered in the Menu commands, the Main window, and the Calibration window.
A. Menu commands
1. Apple Menu — About ICC Profiler: Choose the
About ICC Profiler command from your Apple menu
to display the splash screen for the Scanner ICC
Profiler program. The screen includes the product
logo and the software version number
2. Scanner Menu: The Scanner Menu lets you see
information on your current scanner and your SCSI
chain.
a) Find Plug-in: This command lets you choose the
correct ScanWizard Pro Plug-in driver for the ICC
Profiler program (in case the Plug-in driver cannot
be found).
b) Get Current Scanner Info: This command
provides information on the current scanner. A
dialog box appears showing the scanner model in
use, the SCSI ID number of the scanner, and the
firmware version of the scanner.
.
c) Scanner Probe: This command displays the SCSI
devices on the SCSI chain, as well as the SCSI ID
numbers of the individual devices.
To use this command:
1. Choose the Get SCSI Chain Info command.
2. If your scanner does not show in the list, make
sure it is connected and turned on, then click on
the Probe button in the dialog box.
• Choose the correct interface card in the card
selection box.
• Check the numbered box corresponding to
the SCSI ID of your scanner. Click OK to
close the dialog box