Microtek Artix Scan1100 - Manual (Page 39)

ArtixScan 1100 Hardware User’s Guide 35
English
B. The Calibration Window: Preview and Scan C. The Calibration Window: Aligning targets and
creating the profile
1. Preview: The Preview button performs a preliminary
scan of the target, displaying the entire target image in
the calibration window.
2. Scan: The Scan button scans the target image and
prepares the scanner for the important succeeding
steps of aligning the registration marks and creation of
the profile.
1. Calibrate: This button starts the actual calibration
process in which a custom scanner ICC profile is
created for the scanner. This button is grayed out until
you have performed the required alignment of the three
registration marks on the target.
2. Previous Mark: This button lets you go back one step
to align the previous registration mark.
3. Next Mark: This button lets you go forward one step
to align the next registration mark.
4. Go to Step 1: This button takes you back to the
preview image screen so that you can rescan the target
image and restart the calibration process.
5. Show Patches: This option lets you check the
sampling area of all the color patches. When aligned
properly, the sampling area appears as a green square
in the center of most patches. If any areas fall outside a
patch, realign the registration marks by clicking the
“Previous Mark” and “Next Mark” buttons, and then
reselecting the registration marks until the sampling
areas are centered.
6. Close: This button lets you return to the main screen.