Moxa Technologies Moxa EtherDevice Switch EDS-508 - Manual (Page 69)

EDS-508 Series User’s Manual Featured Functions
3-53
Configuring Line-Swap Fast Recovery
Enable Line-Swap-Fast-Recovery
Setting Description Factory Default
Enable/Disable Check-mark the check box to enable
the Line-Swap-Fast-Recovery function
Enable
Using Set Device IP
To reduce the effort required to repeatedly set up IP addresses, the EDS-508 series comes
equipped with DHCP/BootP server and RARP protocol to automatically set up IP addresses of
Ethernet-enabled devices.
When enabled, the Set device IP function allows MOXA EtherDevice Switch to automatically
assign specific IP addresses to connected devices that are equipped with DHCP Client or RARP
protocol. In effect, MOXA EtherDevice Switch acts as a DHCP server by assigning a connected
device with a specific IP address stored in MOXA EtherDevice Switch’s internal memory. Each
time the connected device is switched on or rebooted, MOXA EtherDevice Switch sends the
device the desired IP address.
Take the following steps to use the Set device IP function: