Motorola SB4100 - Manual (Page 16)

Powering Up the First Time
You must allow 5 to 30 minutes to power up
the first time because the SB4100 must find
and lock on the appropriate channels for
communications.
1 Be sure that your computer is on and the
SB4100 is unplugged.
2 Plug the SB4100 in and check that the
lights on the front panel cycle through
this sequence:
• Power flashes during a self-test. When
the self-test is successfully complete,
the light is solid green.
• Receive flashes while the SB4100
scans for the receive channel.
When the receive channel is
locked, the light is solid green.
• Send flashes while the SB4100 scans
for the send channel. When the
send channel is locked, the light
is solid green.
• Online flashes while the SB4100 is
obtaining configuration information.
When the configuration information
is obtained, the light is solid green.
During normal operation, the Power, Receive,
Send, and Online lights are on and the Activity
light flashes when transferring data between
the SB4100 and your computer.
Introduction Before You Begin Installation Operation Basic Configuration Troubleshooting
To turn on your SB4100,
simply plug it in. It is not
necessary to unplug it when
not in use.
11
SSUURRFFbbooaarrdd
R
TM