Mercedes-Benz Command 209 - Manual (Page 161)

153
Navigation
Route guidance
If an audio source is switched on, e.g. the
radio, the voice output will be mixed with
that of the audio source.
You can individually set the audio volume
differential between voice output/audio
source (
୴ page 64). COMAND mutes navi-
gation voice outputs during telephone/
Tele Aid operation.
Repeating current voice output
̈ Press the left-hand rotary/push-button
v briefly.
Muting current voice output
̈ Press Ö briefly during a voice out-
put. You will hear the next announce-
ment normally.
Switching the voice output off for the
duration of the current route guidance
̈ Press Ö longer than 2 seconds du-
ring a voice output.
You will see the message “Voice output
is muted”.
Switching the voice output on again
The current route guidance has been com-
pleted.
Voice output will automatically switch on
again.
During a voice output
̈ Press the left-hand rotary/push-button
v.
Altering the voice output volume
At the COMAND control unit
̈ Turn the left-hand rotary/push-button
v during a voice output.
COMAND will accept this setting for
following voice outputs.
At the multifunctional steering wheel
You can alter the volume with the steering
wheel keys during a voice output as well.
To raise the volume
̈ Press J.
To lower the volume
̈ Press I.