Motorola 2200 - Manual (Page 137)

137
reset wan-users [all | ip-address ]
This function disconnects the specified WAN User to allow for other users to access the WAN. This func-
tion is only available if the number of WAN Users is restricted and NAT is on. Use the
all parameter to
disconnect all users. If you logon as Admin you can disconnect any or all users. If you logon as User,
you can only disconnect yourself.
reset wan
This function resets WAN inter face statistics.
reset wepkeys
This function allows you to force your wireless WEP key settings back to the default values, if there are
default values. For example, on some models, the WEP keys are based on the serial number. This
allows you to get back those default settings if you have changed them without the need to reset the
entire configuration of the unit.
restart [ seconds ]
Restar ts your Motorola Netopia® Gateway. If you include the optional seconds argument, your Motor-
ola Netopia® Gateway will restar t when the specified number of seconds have elapsed. You must enter
the complete
restart command to initiate a restar t.
show all-info
Displays all settings currently configured in the Motorola Netopia® Gateway.
show backup
Displays the status of the Backup por t, Up or Down, and repor ts the current por t in use.
show bridge interfaces
Displays bridge inter faces maintained by the Motorola Netopia® Gateway.
show bridge table
Displays the bridging table maintained by the Motorola Netopia® Gateway.
show config
Dumps the Motorola Netopia
®
Gateway’s configuration script just as the script command does in
config mode.
show crash
Displays the most recent crash information, if any, for your Motorola Netopia® Gateway.