Maxtor DIAMONDMAX 91536H2 - Manual (Page 2)

Before You Begin
Thank you for your interest in the Maxtor DiamondMax ® 60 AT hard disk drives. This manual provides technical
information for OEM engineers and systems integrators regarding the installation and use of DiamondMax hard
drives. Drive repair should be performed only at an authorized repair center. For repair information, contact the
Maxtor Customer Service Center at 800-2MAXTOR or 408-922-2085.
Before unpacking the hard drive, please review Sections 1 through 4.
C A U T I O N
Maxtor DiamondMax 60 hard drives are precision products. Failure to
follow these precautions and guidelines outlined here may lead to
product failure, damage and invalidation of all warranties.
1
BEFORE unpacking or handling a drive, take all proper electro-static discharge (ESD)
precautions, including personnel and equipment grounding. Stand-alone drives are
sensitive to ESD damage.
2
BEFORE removing drives from their packing material, allow them to reach room
temperature.
3
During handling, NEVER drop, jar, or bump a drive.
4
Once a drive is removed from the Maxtor shipping container, IMMEDIATELY secure
the drive through its mounting holes within a chassis. Otherwise, store the drive on a
padded, grounded, antistatic surface.
5
NEVER switch DC power onto the drive by plugging an electrically live DC source cable
into the drive's connector. NEVER connect a live bus to the drive's interface connector.
6
ELECTRICAL GROUNDING - For proper operation, the drive must be securely fastened
to a device bay that provides a suitable electrical ground to the drive baseplate.
Please do not remove or cover up Maxtor factory-installed drive labels.
They contain information required should the drive ever need repair.