Maxtor DIAMONDMAX 91536H2 - Manual (Page 46)

INTERFACE COMMANDS
7 – 6
Mode Set/Check Commands
Set Features Mode
Enables or disables features supported by the drive. When the drive receives this command it:
1. Sets BSY,
2. Checks the contents of the Features register,
3. Clears BSY and
4. Generates an interrupt.
If the value of the register is not a feature supported by the drive, the command is aborted.
The acceptable values in the Features register are defined as follows:
VALUE DESCRIPTION
0 2 h Enabled Write Cache
0 3 h Set Transfer Mode based on value in Sector Count register
0 5 h Enable Advanced Power Management
4 2 h Enable Automatic Acoustic Management. The sector count register contains the
Automatic Acoustic Management level.
S E C T O R LEVEL
F F h Maxtor specific
FEh Maximum performance
8 1 h - F D h Intermediate acoustic management levels
8 0 h Minimum acoustic emanation level
00h-7Fh reserved
4 4 h Length of data appended on Read Long/Write Long commands specified in the
Identify Device information
5 5 h Disable Read Look-ahead feature
6 6 h Disable reverting to Power-on defaults
8 2 h Disable Write Cache
8 5 h Disable Advanced Power Management
A A h Enable Read Look-ahead feature
B B h 4 bytes of Maxtor specific data appended on Read Long/Write Long commands
C2h Disable Automatic Acoustic Management
C C h Enable reverting to Power-on defaults