Michelin X970 - Manual (Page 10)

2.2 Installing the hardware in a vehicle
• To benefit from better mounting if necessary, unscrew the suction pad slightly from the support.
• Install the mounting system on the windsheild by applying pressure to the suction pad and then turning the screw
clockwise.
• Start your vehicle.
• Connect the cigarette-lighter cable to your ViaMichelin Navigation X-970 mounting system (socket on the right-
hand side) and then to your vehicle’s cigarette-lighter socket.
• Mount your ViaMichelin Navigation X-970 by sliding it onto the mounting system as shown on the installation
diagram provided.
• Turn on your ViaMichelin Navigation X-970 and plan your journey.
FOR YOUR SAFETY:
- Make sure you position the mounting system in a place where it will not obstruct visibility or
interfere with driving the vehicle.
- Make sure you position the cigarette lighter cable in a place where it will not obstruct visibility or
interfere with driving the vehicle.
- Make sure you plan your destination when the vehicle is stationary. We strongly recommend that
you not operate the device while driving.
2.3 Installing the software pre-recorded on the SD card
ViaMichelin Navigation is a “Plug & Drive” solution: simply install the SD memory card provided on the left side of your
PND. The card must be fully inserted face up in the direction of the blue arrow as shown in the illustration below:
To remove the SD card from the device, press on the side of the SD card and release. The SD card will then be
ejected from the device.
Then follow the installation instructions displayed on your screen:
• Select the language for the menus
• Configure keyboard
• Select the voice guidance language
When choosing the voice guidance language, you may select a traditional pre-recorded voice (6 languages
available: American English, English, French, German, Italian, Spanish) or voice synthesis
(American English),which will guide you with instructions concerning road names, directions, road signs
• Voice guidance settings
• Select the distance unit
• Select map display
• Time display format
• Set the time
8