Michelin X970 - Manual (Page 43)

You can now choose to display your POIs from the options:
• My Favorites / My personal folders
• Addresses
• Hotels
• Restaurants
• Tourism
• My POIs
• Click “More details” to access the subcategories.
• Click “Deselect all” to display no POI category.
6.5 Warner
• Click “Alert”.
You can change the following options:
• Speed warning
use this option to set the speed beyond which the warning signal will
sound, depending on the 4 road categories programmed in the system.
• POI Warner emits an audible warning when passing near a POI.
• My ViaMichelin warning emits an audible warning when passing near a saved address.
• Warning Signal use to set the sounds for the various warners.
6.5.1 Speed warning
• Click “Speed warning ”.
• Click the left or right direction arrows to select the setting you want, depending on the type of road selected, or
click the speed to select the desired speed from the list.
• Click on “Activate ”/”Desactivate ” at the bottom right of the screen to switch this function on and off.
The default speeds in the “Speed warning ” table are:
Highways
130 km/h 80 Mph
Expressways 110 km/h 70 Mph
Roads 90 km/h 55 Mph
Towns 50 km/h 30 Mph
The range of speed limit settings for the type of road is between 30 kph and 180 kph or between 25 mph and 110mph.
This function takes account of the type of road given in the map database without adding more detail about the
surroundings or special features of a section.
For example:
A highway may be limited to 55 mph on some sections instead of 70 mph by default. When the map database
identifies an “expressway” it will not indicate the section limited to 55 mph. A “road”, on the other hand, may have
the same speed limit as an expressway in some places. The Speed Warner will then indicate excess speed although
the traffic regulations authorize this speed.
“Speed warning ” should therefore be used for information, but as with all navigation information supplied by your
ViaMichelin Navigation X-970, this information is subject to traffic regulations.
6.5.2 POI Warner
• Click “POI Warner”.
• Tick the boxes by the POI categories for which you want to trigger an audible signal when they are nearby:
• Click “More details” if you want to break your selection down into subcategories of POIs.
• Click “Deselect All” to switch off warners on all POI categories.
Activating a “POI Warner” for a POI category leads to POIs of this category being displayed.
41