Minicom Advanced Systems Minicom Supervisor Phantom - Manual (Page 27)

Operating the Phantom system with the Control software
4-7
Single computer settings
To see all the settings of a single computer right click on the computer icon. The settings appear as in the
figure below.
Note! There is no Select box to check.
Figure 4-7 The single computer Settings box
Loading a saved configuration
To load a saved configuration:
From the File menu choose Open.
The factory default settings
To view to the factory default settings:
From the File menu choose New.
Reminder!
All changes done with the Control software are only reflected in the OSD AFTER pressing .
Password protection
When the Phantom system is password protected, the Control software behaves in exactly the same way as the
OSD. You must type in the required password to access the Control software. The access you gain depends on
the security status – exactly as with the OSD.
To change the security access, close and reopen the Control software, and type in the different password.
Administrator (Status A) - Highest
The Administrator can:
• Set and modify all Passwords and security profiles
• Fully access any remote computer
• Use all functions
Supervisor (Status S) - Middle
The Supervisor can:
• Fully access any remote computer
• Scan computers.