Monessen Hearth DFX24C - Manual (Page 33)

33D4047 33
DFX & DBX Series Vent Free Fireplaces OPTIONAL ACCESSORIES
INSTALLING OPTIONAL FIREBRICk
PANELS
1. Remove optional firebrick panels from packaging. Check
that you have the following:
• 3 firebrick panels
• two () retainer brackets
• two () black screws
If any part or parts are missing, contact dealer where
you bought fireplace.
. Turn off fireplace and allow to cool.
3. Remove fireplace screen, Page 17, Figure 17 and
logs.
4. Place rear firebrick panel on back wall of firebox. Set
bottom of panel behind the bracket tabs of the grate.
Figure 36
5. Place one of the side firebrick panels in cabinet. Line
up the hole in the retainer clip with the hole inside the
firebox. Using Phillips screwdriver, attach the retainer
bracket to inside of firebox. Figure 37
6. Repeat step five for the other firebrick side panel.
FP2520
install back brick
Rear Firebrick
Panel
Bracket Tabs
FP50 Figure 36 -
Install Back Firebrick Panel
FP2521
install side brick
Hole
Retainer
Clip
Side Firebrick
Panel
Screw
FP51
Figure 37 -
Install Side Firebrick Panel
BLACk TRIM INSTALLATION
DFX24C/DBX24C
1. Remove black trim from protective packaging. Remove
four (4) black screws and two () 90° angle trim brackets
from owner’s manual packaging.
. Lay trim on floor and match corners of side trims to top
trim. Figure 38
FP2522
attach trim brackets
FP2523
seaparate trim
To Separate Trim
FP53
Figure 38 -
Match and Join Corners of
Black Trim with Trim Brackets
FP5