Monessen Hearth DFX24C - Manual (Page 34)

34 33D4047
DFX & DBX Series Vent Free Fireplaces OPTIONAL ACCESSORIES
3. Use one 90° angle trim bracket to join the corner of
one piece of side trim to the corner of the top trim
piece. Figure 38. A rubber hammer or handle of a claw
hammer will help secure the corners.
4. Repeat for other side.
NOTE: If you do not attach the trim at the correct
corners, use a hammer and screwdriver to tap on the
one end of the 90° angle bracket. This will separate the
two pieces of trim. Figure 39
5. Place assembled black trim on front of heater. Using four
(4) black screws, secure black trim to sides of heater.
Figure 39
FP2524
attach trim
Holes for Black
Screws
Black Screw
Black Trim
FP54
Figure 39 -
Attach Assembled Trim to Fireplace
4. Hold the corners together securely. Tighten screws on
bracket with flat head screwdriver. Make sure the cor-
ners are flush and there are no spaces. Do not over
tighten screws. Figure 41
5. Repeat for other side trim.
6. Slide assembled trim over the top and down the sides of
the fireplace. Flush trim with front of fireplace as shown
in Figure 42.
7. Align holes in assembled trim with holes in side of fire-
place. Using a Phillips screwdriver, attach trim with four
(4) screws provided — two for each side of fireplace.
Tighten snuggly. Figure 43
BLACk TRIM INSTALLATION
DFX32C
1. Remove trim from protective packaging. Be careful not
to scratch the trim. Remove two () 90° angled mounting
brackets and two () 90° angled shims.
. Lay trim face down on the floor. Line up the 45°-angled
corners of the top trim with the 45°-angled corners of
the side trims.
NOTE: Both ends of the top piece of trim are mitered.
Figure 40
3. Slide one (1) 90° angled bracket (with attached screws)
and one (1) 90° angled shim in the outside corner slot
where the top and side trims meet. Figure 41
FP2525
mitered corners
45° Angled
Corners
FP55
Back of Trim
Assembly
Figure 40 -
Align Corners of Trim Pieces
FP2526
secure corners
Bracket
Shim
FP56
Figure 41 -
Secure Corners
Outside
Corner Slot
Bracket
Screws
No Spaces
Where Corners
Join
Ensure Corners
are Flush