Minicom Advanced Systems 5UM20114 - Manual (Page 46)

SMART CAT5 SWITCH 16 IP
.
45
0.0.0.0/0 matches any IP packet
Policy - Determines what to do with matching packets. They are accepted or
dropped.
NOTE: The order of the rules is important. The rules are checked in ascending
order until a rule matches. Rules below the matching one are ignored. The default
policy applies if no match has been found.
Append a rule – To add a rule to the end of the rule list: Enter the IP/Mask and
set the policy. Then press .
Insert a rule - To insert a rule according to the rule number: Enter the rule
number, IP/Mask and set the policy. Then press . All rules with higher
numbers are shifted below.
Replace a rule - Enter the rule number, IP/Mask and set the policy. Then press
.
Delete a rule - Enter the rule number and press .
Anti Brute Force Settings
Anti Brute Force Settings lets you block access to a specific user, for a fixed
amount of time if a predefined number of unsuccessful login attempts by this user
occurred.
Max. number of failed logins – insert a maximum number or leave it blank to
disable Anti Brute Force.
Block time - Block time in minutes - insert a number or leave it blank.
To unblock blocked users. Connect to the Smart 16 IP Serial 1 port using terminal
software, and type unblock. A list of blocked users appears. Select the users to
unblock.
33. SNMP Settings
The following information is available via SNMP:
• Serial number
• Firmware version
• MAC address / IP address / Netmask / Gateway of LAN interface
• Configured users