Minicom Advanced Systems 5UM20114 - Manual (Page 48)

SMART CAT5 SWITCH 16 IP
.
47
Read Community - This is the SNMP community, which allows you to retrieve
information via SNMP.
Write Community - This community allows you to set options and reset Smart
16 IP or the host via SNMP.
System Location - Type a description of the physical location of the host. This
will be used in reply to the SNMP request "sysLocation.0".
System Contact - Type a contact person for the host. This will be used in reply to
the SNMP request "sysContact.0".
Enable SNMP Authentication Traps -When checked, an SNMP trap will be
sent in case somebody has tried to access Smart 16 IP via SNMP using a wrong
SNMP community.
Enable Smart 16 IP Authentication Traps - When checked, an SNMP trap will
be sent if somebody tries to login via the Web front-end. Both successful and
failed logins trials will be indicated. Furthermore, there will be notification about
other security violations like trying to perform an action via Web front-end for
which a user has no permission.
Enable Host Traps -When checked, Smart 16 IP will send SNMP traps
whenever the host is reset, powered down or powered up.
Trap destinations Enter IP addresses, to which the traps will be sent. For every
IP address, set an according community so that your management client can
identify the SNMP traps.
After making the entries click .
The Smart 16 IP SNMP MIB
Click the link to access the Smart 16 IP SNMP MIB file. With it, an SNMP client
can communicate with Smart 16 IP. Copy the MIB file and import it to the SNMP
client software.
34. IPMI Settings
The Smart 16 IP IPMI (Intelligent Platform Management Interface) is an
additional way to power on or off the system or to perform a hard reset. You can
also show an event log of the host system and the status of some system sensors
(i.e. temperature). If your host system supports IPMI, you can access it in one of
the following ways:
• IPMI over Serial
• IPMI over LAN