Philips Magnavox VRX262AT - Manual (Page 11)

5
3
4
• To skip this feature and play a tape
immediately, insert a tape with its
record tab removed. Or, to skip step
3, press the MENU button. All on-
screen displays will be in English. To
skip step 5, press the STOP button.
Channels will not be programmed,
and CHANNELS NOT SET will
appear on-screen.
• If you try to program channels
when there is no antenna or cable
connected to the VCR, programming
will appear to take place, but even-
tually a NO TV SIGNALS message
will appear on-screen. Connect an
antenna or cable to the VCR and
try again. You may need to follow
the steps on page 12.
Helpful Hints
Turning on Your VCR 11
Before turning on your VCR, make sure there are batteries in the
remote control and the VCR and TV are connected correctly.
● Follow the steps on this page only when you plug the VCR
power cord into the wall outlet for the first time.
● You may not be able to program channels at step 5 if you are
using a Cable Box.
1
Turn the TV on. Set it to the same channel as the
CH3/CH4 switch on the back of the VCR.
2
Press the POWER button to turn on the VCR. The VCR
light and the PWR. light will appear on the VCR display panel. The
language select display screen shown below will appear. (If it does
not appear, follow the steps on page 12 to program channels and
page 17 to select a language.)
3
Within 60 seconds, press the Number 1 button to select
English on-screen displays or the Number 2 button to
select Spanish on-screen displays.
4
Press the MENU button. The channel program display shown
below will appear. The display will disappear after about 60 sec-
onds if you do not press any buttons.
TO SELECT PUSH NO. SHOWN
1 ENGLISH ON
2 ESPAÑOL
MAKE SELECTION OR
PUSH MENU TO CONTINUE
CONNECT ANTENNA OR CABLE
TO VCR
THEN . . .
PUSH CH UP KEY
OR . . .
FOR PLAY ONLY – PUSH STOP
1
5
Press the CHANNEL (Up) button to begin automatic
channel programming. AUTO SET PROCEEDING PLEASE
WAIT will appear on-screen. The VCR will place all of the chan-
nels you receive into its memory, so when you scan through chan-
nels using the CHANNEL (Up/Down) buttons, you’ll only scan
through channels that you receive. When all channels are pro-
grammed, CHANNELS ARE SET will appear on-screen briefly.
Then the TV will go to the lowest channel programmed.
REW
PLAY
POWER
VCR PLUS+
SPEED
VCR/TV
EJECT
CHANNEL
REC/OTR
STATUS/EXIT
SLOW PAUSE/STILL
MENU CLEAR MEMORY
STOP
F.FWD
1 2 3
4 5 6
7 8 9
0 +100
TIME SEARCH
Turn on the TV.
2