Philips Magnavox VRX262AT - Manual (Page 25)

Read and follow the steps below to record a television program.
1
Turn the TV on and set it to channel 3 or 4, whichever the
CH3/CH4 switch on the back of the VCR is set to.
Recording 25
2
Insert a tape with its record tab intact (see page five) in the
VCR. The power will come on, and the Cassette-Inside light will
appear.
3
If the VCR light appears on the display panel of the VCR, go to
step 4. If the VCR light does not appear, press the VCR/TV
button once.
• If the REC(ord)/OTR button is
pressed while a tape without a
record tab is in the VCR, the VCR
will eject the tape and PROTECTED
CASSETTE CANNOT RECORD will
flash on-screen.
• Other recording options are on
pages 26-36.
• You can change the tape speed while
the VCR is recording, but some distor-
tion will appear on the tape.
• The VCR will record in a preset vol-
ume.
Helpful Hints
4
Press the (Tape) SPEED button on the remote control until
the desired tape speed (see pages 30 and 48 for details) appears
on the TV screen. The tape speed will disappear from the screen
after about five seconds.
5
Press the CHANNEL (Up/Down) buttons or the Number
buttons to select the channel to be recorded.
6
Press the REC(ord)/OTR button once to start recording. The
REC light will appear on the VCR’s display panel.
If the REC(ord)/OTR button is pressed when there is not a tape
in the VCR, NO CASSETTE will flash on-screen.
7
To pause the recording (for example, during commer-
cials), press the PAUSE/STILL button on the remote control
or the PAUSE button on the VCR once. The REC light will flash.
To start recording again, press the REC(ord)/OTR button
or the PAUSE/STILL button again. The REC light will come
on again.
8
To stop recording, press the STOP button on the remote
control.
3
4
5
1 Turn on the TV.
2 Insert a tape in the VCR.
6
7
8
REW
PLAY
POWER
VCR PLUS+
SPEED
VCR/TV
EJECT
CHANNEL
REC/OTR
STATUS/EXIT
SLOW PAUSE/STILL
MENU CLEAR MEMORY
STOP
F.FWD
1 2 3
4 5 6
7 8 9
0 +100
TIME SEARCH