Phone pattern configuration, Hone, Attern – MicroNet Technology SP5001A/S User Manual
Page 52: Onfiguration
5.6. Phone Pattern Configuration
For tone simulation, FXS Gateway adopts dual frequencies as traditional telephone
does. Default tone value is set according to U.S. tone specification. Users may adjust
the values to their own country’s tone specification or users-defined tone specification.
Ring Tone
Set Ring frequency, on time, off time. Gateway will give ring to
phone set to trigger ring. If user found that phone set cannot ring
when having incoming call, please try to increase ring frequency
here.
y
ringing frequency: 15 ~ 100 (Unit: Hz)
y
ringing ring ON/OFF: 0 ~ 8000 (Unit: ms)
y
ringing level: 0 ~ 94 (Unit: V)
y
tone frequency: 0 ~ 65535 (Unit: Hz)
y
tone freqLevel: 0 ~ 65535 (Unit: mVrms)
y
tone Tone ON/OFF: 0 ~ 8000 (Unit: ms)
Ring Back Tone
Set ring back tone parameters
Busy Tone
Set busy tone parameters
Dial Tone
Set Dial tone parameters
2nd Dial Tone
To configure the value of the local 2
nd
dial tone
51